Maxi Dot Display - Skoda Octavia Owner's Manual

Main menu

First read and observe the introductory information and safety warn-
ings on page 31.
Operating the MAXI DOT display » page
Main menu points
The following information can be selected (depending on the equipment installed
on the vehicle).
Driving data » page 29
■
■ Assist systems » page 164, » page 154
Navigation » operating instructions for Infotainment, chapter Navigation sys-
■
tem (NAV button)
■ Audio » operating instructions for Infotainment, chapter Audio (MEDIA button)
Telephone » operating instructions for Infotainment, chapter Communication
■
(PHONE button)
■ Vehicle » page 14, Auto-check control
Lap timer » page 32
■
Menu item wizard
In the menu item Assist systems the Front Assist and the Lane Assist can be
confirmed and activated or deactivated .
The menu item Assist systems in the main menu can also be opened by pressing
the button on the control lever» Fig.
E
Note
If the MAXI DOT display shows warning messages, these messages must be con-
firmed in order to access the main menu
tem .
32
Using the system
Fig. 10
Operating lever: Button to open
the menu item wizard
26.
10.
» page 26, Using the information sys-
Lap timer (Stop watch)

First read and observe the introductory information and safety warn-
ings on page 31.
The Laptimer function offers the possibility of calculating the lap time, for exam-
ple when driving on a race course. The measured time is shown in the display.
Operation of the lap timer function
The calculated times are displayed in minutes, seconds and deciseconds.
Activate Laptimer function
›
From the main menu of the display select the menu item Lap timer.
The following functions are available.
■ Start - start the timing manually or continue the interrupted measurement
Since start - Start the timer automatically upon start-up
■
Statistics - Evaluate and reset the measured times
■
Time measurement
Manually start the measurement
›
Select the menu item Lap timer - Start.
Start the measurement automatically
›
Select the menu item Lap timer - Since start. Timing will begin automatically
when starting up.
Start timing of next round
›
Select the menu item New lap during timing.
During timing, information about the fastest and the last lap time are also shown
in the display.
Measure split time
›
During the timing, select the menu item Split time. The split time data is dis-
played for about 5 seconds in the display.
The split time can be measured repeatedly during a round.
Stop measurement
›
During the timing, press the menu item Stop.
The time measurement is stopped, the following functions are now available.
Continue - Continue measurement of the current lap time
■
New lap - Start measurement of the next lap time.
■

» page 26, Using the information system.
