Driving Data (Multifunction Display) - Skoda Octavia Owner's Manual

Driving data (Multifunction display)


Introduction
This chapter contains information on the following subjects:
Memory
Information overview
Warning at excessive speeds
The multifunction display only operates if the ignition is switched on.
After the ignition is switched on, the function that was last selected before
switching off the ignition is displayed.
Individual menu items can be shown or hidden in the Infotainment
sanleitung Infotainment, chapter Vehicle settings (CAR button).
WARNING
Concentrate fully at all times on your driving! As the driver, you are fully re-
sponsible for the operation of your vehicle.
Note
In some national versions the displays appear in the Imperial system of measure-
ment.
Memory

First read and observe the introductory information and safety warn-
ings on page 29.
The multifunction display is equipped with three automatic memories.
The display of the selected memory varies depending on vehicle equipment.
Since start (MAXI DOT display) or "1" (segment display)
The memory collates the driving information from the moment the ignition is
switched on until it is switched off.
New data will also flow into the calculation of the current driving information if
the trip is continued within 2 hours after switching off the ignition.
If the trip is interrupted for more than 2 hours, the memory is automatically
erased.
Long-term (MAXI DOT display) or "2" (segment display)
The memory gathers driving information from any number of individual journeys
up to a total of 99 hours and 59 minutes driving or 9999 kilometres driven.
The memory is deleted when either of these limits is reached and the calculation
29
starts all over again.
29
Since refuel (MAXI DOT display) or "3" (segment display)
31
The memory gathers driving information since the last refuelling.
The memory is erased automatically the next time you fill up.
Select memory
›
Select the corresponding element of the travel data
» Bedienung-
mation system.
Confirm the element again to switch between the individual memories.
Resetting
›
Select the corresponding element of the travel data
mation system.
›
Select the desired memory.
›
Press and hold button
The following values of the selected memory are set to zero.
›
Average fuel consumption.
›
Distance driven.

›
Average speed.
›
Driving time
Note
Disconnecting the vehicle battery will delete all memory data.
Information overview

First read and observe the introductory information and safety warn-
ings
The amount of information displayed may differ depending on the equipment.
or adjustment wheel
B D
on page 29.
» page 26, Using the infor-
» page 26, Using the infor-
» Fig. 7 on page 26.


29
Information system