Skoda Octavia Owner's Manual page 77

›
Hold the rear head restraints on the sides with both hands and move them up-
wards » Fig. 49.
›
To move the head restraint downwards, press and hold the safety button
with one hand and press the head restraint downwards with the other hand.
The head restraints and the front seats must be adjusted to match the body size
at all times and the seat belt must always be fastened properly to provide the
most effective levels of protection to the passengers
position.
Removing/installing
Only the real head restraints may be removed.
›
Pull the head restraint out of the seat backrest as far as the stop.
›
Press the locking button in the direction of arrow
press the locking button into the opening
width of maximum 5 mm and pull out the head rest.
›
To re-insert the head restraint, push it far enough down into the seat backrest
until the locking button clicks into place.
WARNING
The head restraints must be correctly adjusted in order to offer effective
■
protection for the occupants in the event of an accident.
Never drive with the head restraints removed - risk of injury.
■
If the rear seats are occupied, the respective rear head restraint must not be
■
in the lower position.
Note
For the sports seats, the head restraints are integrated into the front seat
■
backrests. These headrests cannot be adjusted by height or removed.
The middle rear head restraint is only adjustable in two positions.
■
74
Using the system
1
» page 177, Correct seated
» Fig. 49 simultaneously
1
using a flat screwdriver with a
2
Memory function of the electrically adjustable seat

First read and observe the introductory information and safety warn-
ings on page 71.
The memory function for the driver's seat provides the option to store the posi-
tions of the driver's seat and the external mirrors. Each of the three memory but-
tons » Fig. 50 can be assigned a set position.
B
Storing seat and exterior mirror settings for driving forward
›
Switch on the ignition.
›
Adjust the seat to the desired position.
›
Adjust both of the exterior mirrors
›
Press the button » Fig.
A
SET
›
Within 10 seconds after pressing the
button .
B
An acknowledgment sound confirms the storage.
Saving front passenger mirror settings when reversing
›
Switch on the ignition.
›
 Press the required memory button
›
Adjust the rotary knob for the mirrors to the position  or in right-hand drive to
the position  » page 69.
›
Engage reverse gear.
›
Adjust the front passenger's mirror to the desired position
›
Disengage reverse gear.
The set position of the exterior mirror is stored.
Retrieving the saved setting
›
Tap the desired memory button
and the driver's door is opened.
Fig. 50
Memory buttons and SET button
» page 69.
50.
button, press the desired memory
SET
» Fig. 50.
B
» page
» Fig. 50 when the ignition is switched off
B
69.
