Installing Shunt/Terminal Strip - Enterasys X-Pedition XSR-3150 Getting Started Manual

Cable, CompactFlash and Accessory Specifications

Installing Shunt/Terminal Strip

To install the shunt or terminal strip, attach two dual-pin units vertically to P1 and P2 four-pin
jumpers corresponding to the RJ-45 port using a balun, as shown in
ports on the NIM card connected to 120-ohm lines do not require shunts.
Port 0
A-18
Figure A-20 Installing a Termination Shunt on BRI-S/T NIM Card
T1
P 1
F1 F2 F3 F4 F5 F6
J1
Port 0
R eceive P air Term ination
T2
P 2
F7 F8
P ort 1
J2
P ort 1
Figure A-20. Any other RJ-45
Transm it Pair Term ination