Copper/Fiber-Optic Ethernet Nims - Enterasys X-Pedition XSR-3150 Getting Started Manual
X-pedition security router
Hide thumbs
Also See for X-Pedition XSR-3150:
- Getting started manual (110 pages) ,
- Datasheet (6 pages) ,
- Quick reference card (2 pages)
Table of Contents
Advertisement
Copper/Fiber-optic Ethernet NIMs
The single-port Copper or Fiber-optic Ethernet NIMs, shown in
provide interfaces for half and full-duplex 10/100Base-T or fiber-optic 100Base-F transmission
over LAN or WAN networks, respectively. The Copper Ethernet NIM incorporates a standard 8-
pin modular RJ-45 connector and the Fiber-optic Ethernet NIM has an MT-RJ multi-mode
interface. Both NIMs conform to IEEE 802.3 and PCI 2.2 standards.
Refer to
Figure A-5
Regulatory/Safety Compliance
The Copper and Fiber-optic Ethernet NIMs comply with these requirements: IEE 802.3, UL 1950,
CSA No. 950, EN 60950, and IEC 950 (CB Scheme Report).
Figure A-3
Figure A-4
for Copper Ethernet NIM pinout assignments.
Figure A-5
Copper Ethernet NIM Port Pinouts
Eth 1 (Copper)
Pin 8
Pin 1
Cable, CompactFlash and Accessory Specifications
Figure A-3
Copper Ethernet NIM
Fiber-optic Ethernet NIM
Copper
Pin
Signal
1
Tx Data +
2
Tx Data -
3
Rx Data +
4
Not Used
5
Not Used
6
Rx Data -
7
Not Used
8
Not Used
and
Figure
A-4,
XSR Getting Started Guide A-7
Advertisement
Table of Contents
