Enterasys X-Pedition XSR-3150 Getting Started Manual page 107

LED
VPN
COM(munication)
Ethernet Port 1, 2, 3
Fiber/Copper GBIC
(Ethernet) Port
BRI NIM Port 0/1
ADSL NIM 1
ADSL NIM 2
T3/E3 NIM:
•LOS (Loss of Signal)
•LOF (Loss of Frame)
•Alarm
•Enable
Copper Ethernet NIM
Fiber-optic Ethernet NIM
Table A-3 LED Description (continued)
State Function
ON VPN tunnel is up
OFF No VPN tunnel connected
Blinking Port is transmitting or receiving data
OFF Port is idle
Amber only ON 10Base-T link is auto-detected
Green only ON 100Base-T link is auto-detected
Both ON 1000Base-T link is auto-detected
Blinking Port is transmitting or receiving data
OFF Link is down
Both OFF Port is configured as copper
Link LED ON Fiber link up
TX LED Activity on fiber port
Blinking
Connected to BRI link is activated and ready for traffic.
switch This LED is located on the NIM card.
Blinking Line is in training mode (syncing with DSLAM)
ON Training mode complete, line is operational
OFF Line is down
Blinking Traffic activity in sync with data traffic
Red ON XSR cannot latch onto the frequency
Red ON Both sides of link cannot synchronize frames
Amber ON Error condition detected
Green ON Link is up and running
Link ON 100Base-T link is link is auto-detected
Link OFF 10Base-T link is link is auto-detected
Activity Blinking Port is transmitting or receiving data
Link ON 100Base-F link is link is auto-detected
Activity ON Port is transmitting or receiving data
Cable, CompactFlash and Accessory Specifications
XSR Getting Started Guide A-23