Installing The Service Station - Rena Mach 8 Operation Manual

Installing the Service Station

THIS PROCESS MUST BE PERFORMED BY A QUALIFIED/TRAINED PERSON.
NOTICE:
Due to the technical nature of this procedure; it should only be performed by a qualified
technical support person or someone that has been properly trained on this procedure. Please contact your
technical support representative. Please use nitrile powder-free gloves and have plenty of paper towels on-
hand for these procedures.
The Service Station fits in the slot immediately above the Ink Tank slots.
PROCEDURE:
1. Make sure the printer is powered OFF.
If the printer is not powered off, press the ON/OFF button once and wait about 45 seconds for the print
engine to power off (all control panel light's off). Then turn the Main Power Switch OFF.
2. Open the Top Cover.
3. Open the Ink Tank Door (hinged at bottom) to expose the
"Service Station Slot".
Tip: On older units you
will need to remove the
Exit Roller Cover by
removing the four (4)
screws. This is not
necessary on newer
units.
4. If you are installing a New Service Station; carefully remove the Service Station from its packaging.
NOTE: Loose parts may fall out. Keep wiper roller side facing up, when removing the packaging.
5. Check to be sure that the wiper roller latches are secure.
Make sure the latches for the Wiper Roller are fully latched and secured
before installing the Service Station. Current versions of this assembly also
have latch retaining screws that secure the latches from opening in transit
or use. Make sure theses screws have been tighten (do NOT over-tighten).
NOTE: Early versions of this assembly did not have latch retaining screws.
CAUTION
Ink Tank
Door
Check the latch at each end of
CAUTION!
SECTION 7
MAINTENANCE
Service Station
Slot
the wiper roller.
Tighten
71