Installing A Print Cartridge - Rena envelope imager III Instruction Manual

The ink in the print cartridge may be harmful if swallowed. Keep new and used cartridges
out of reach of children. Discard empty print cartridges in the proper manner.
1. Remove the top cover.
2. Remove the Cartridge
from the shipping
container by peeling top cover off.
Be careful not to touch the copper
ribbon.
3. Gently remove both pieces of
tape covering the ink nozzles on
the print cartridge. Be careful not
to touch the copper nozzles.
4. Raise the latch all the way up on the Print
Head Assembly. Hold cartridge from the
notched handle on top of the cartridge. Gently
insert cartridge down at approximately a 45
degree angle into the cradle.
5. Push down on the ink cartridge until it is
seated on the bottom of the Print Head
Assembly. Press down blue latch to lock ink
cartridge in place. If the lever is difficult to
close, check placement of the cartridge.
When properly set, the lever will catch the
back of the cartridge and guide it securely
into the locked position.
User's Manual - Revision C
CAUTION
Section 2 - 4
Setting up the Printer
Installing a
Print
Cartridge
Note
: The Envelope
Imager III was
designed to use the
HP C8842A print
cartridge or HP
C6119A Ink
Reservoir System
.