Install Service Station - Rena Mach 5 Quick Start Manual

4 th STEP

Install Service Station:

Warning: This step must be performed by the
installing dealer. Severe damage may result from
improper installation.
The service station is shipped separately and is
located in the Accessory Box. Make sure that the
main power switch is in the OFF position.
DO NOT attempt to proceed without reading the
MACH 5 Operator's Guide. Refer to the section on
installing the Service Station, as this important
process requires attention to detail.
After it's installed properly, the MACH 5 will
automatically calibrate the Service Station and you
are now ready to proceed.
th
5 STEP
Load MACH 5 Software:
At this time, locate your USB Printer Cable in the
accessory box. From the Operation CD Main Menu,
choose the option that says Install Printer Software
and follow the instructions on screen.
When the installer program says to connect the printer
to the computer, plug the USB cable into the printer,
then your computer. Continue to follow the prompts,
and accept any messages from Windows asking if you
wish to continue the installation. If your firewall asks
for permission, grant access to the software.
Once complete, you will see
the M Series Driver in
your list of available
printers.
Also installed is the
Toolbox (look for the
Memjet folder on the
Start Menu), which
gives you advanced
control of your MACH 5.
QUICK START GUIDE
6 th STEP
Install Ink Tanks & Printhead:
Open the top cover on the MACH5. Press the Printhead Release
Button (located as shown). This will unlock the Printhead latch.
WARNING! Never attempt to open
the Printhead latch manually when
in the closed/locked position. Severe
damage will result. Use the Print-
head Latch Release button from the
Printhead latch Release button.
Remove the Fluidic Cap Protectors. Open the Ink Tank Door & release
the Tank Latches. Insert the five ink tanks into their slots (latches are
marked) label side up. Pull tanks back about an inch then re-insert to
make a good connection. Close latches, ensuring both sides snap into
place. Remove the Printhead from its packaging.
Insert the cartridge on an angle so the ink ports face the ink couplings
and click it forward into place. Once the cartridge is installed, close the
Printhead latch. The MACH 5 will prime the Printhead with ink
automatically. This process will take a few minutes. Please refer to the
Operator's Guide for additional instructions to run the Printhead
Conditioning Routine.
NOW YOU'RE READY TO PRINT!
Printhead Latch
Printhead Release
Button
Gently remove the protective tape.
Wet one of the included lint-free wipes
with a good amount de-ionized water
and wipe the Print-head nozzles. Be
careful to not wet the contacts.