Table of Contents
Advertisement
SECTION 1
GETTING ACQUAINTED
Rear View
Output Stacker Power Out – Connect power cord from optional High Capacity
1.
Output Stacker here. Outlet is rated for 1A, 115VAC.
Main Power Switch, Receptacle and Fuse– Plug in power cord here. Switch turns
main power ON/OFF. Fuse (2.5A, 250V, slow blow) provides over-current protection.
2.
(IMPORTANT: Use Control Panel ON/OFF button to power-down Print Engine
before turning off main power.)
3.
USB Port Connection – The USB cable, from the computer, attaches here.
4.
Network Connection – The network cable plugs in here.
Stacker Interface Port – Stacker Interface Cable for the optional, Automatic High
5.
Capacity Output Stacker connects here.
Feed Rollers and Sheet Separators – Feeds and separates media; delivering one
6.
piece at a time into the printing area.
Skew Control Bridge – Adjust so the Skew Control Guide can be positioned near
7.
the trailing edge of the media.
Skew Control Guide– Adjust to the width of the media; to keep the media stack
8.
square and control skew.
9.
Right Media Side Guide – Adjustable to fit different widths of media.
Feed Table Extensions – Slide forward/back, using finger-hole, to support different
media widths. Slide one or both forward to support wider media. Slide one or both
back to support narrower media.
10.
Tip: If Right Media Side Guide won't move past a certain point; check to be sure the
Feed Table Extensions and Separator Lockdown/Release Tabs, aren't interfering
with the guide.
Feed Table – Load up to 5,000 sheets (10 reams). Raises and lowers with load.
11.
Media feeds from top of stack. Feed Table Sensor detects presence of media.
2
Feed Table Sensor
Advertisement
Table of Contents
