Table of Contents
Advertisement
Channel 5 – Strobe
0-9
10-255
Channel 6 – Color Programs
0-24
25-49
50-74
75-99
100-124
125-149
150-174
175-199
200-224
225-249
250-255
Maintenance
The Showtec Compact Par requires almost no maintenance. However, you should keep the unit clean.
Otherwise, the fixture's light-output will be significantly reduced.
then wipe the cover with a damp cloth. Do not immerse in liquid. Wipe lens clean with glass cleaner and
a soft cloth. Do not use alcohol or solvents. Keep connections clean. Disconnect electric power, and
then wipe the connections with a damp cloth. Make sure connections are thoroughly dry before linking
equipment or supplying electric power.
The operator has to make sure that safety-relating and machine-technical installations are to be
inspected by an expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are to be
inspected by a skilled person once a year.
The following points have to be considered during the inspection:
1. All screws used for installing the device or parts of the device have to be tightly connected and must
not be corroded.
2. There may not be any deformations on housings, fixations and installation spots.
3. Mechanically moving parts like axles, eyes and others may not show any traces of wearing.
4. The electric power supply cables must not show any damages or material fatigue.
Replacing a Fuse
Power surges, short-circuit or inappropriate electrical power supply may cause a fuse to burn out. If the
fuse burns out, the product will not function whatsoever. If this happens,
so.
1.
Unplug the unit from electric power
2.
Insert a screwdriver into the slot in the fuse cover.
3.
Remove the used fuse. If brown or unclear, it is burned
4.
Insert the replacement fuse into the holder where the old fuse was. Reinsert the fuse cover. Be sure to
use a fuse of the same type and specification. See the product specification label for details
No Function
Strobe effect, from slow to fast (0-20 flashes/sec.)
29 static color program Mode via Channel 2
Program 2 (7-color, gradual change) R, RG, G, GB, B, RB, RGB
Program 3 (3-color, gradual change) R, G, B
Program 4 (7-color, color switch) R, RG, G, GB, B, RB, RGB
Program 5 (3-color, color switch) R, G, B
Program 6 (fantasy change 1)
Program 7 (fantasy change 2)
Program 8 (red gradual change)
Program 9 (green gradual change)
Program 10 (blue gradual change)
Sound-controlled
source.
Disconnect the mains power supply, and
Gently pry up the fuse cover.
out.
16
follow the directions below to do
The fuse will come
out.
Hide quick links:
Advertisement
Table of Contents
