Mazda 6 Training Manual page 175

*1
: If a malfunction was detected in the previous driving mode, the light remains illuminated until the wheel-speed
sensor is verified to be normal.
*2
: The warning light illuminates during rear wheel malfunction.
*3
: Stops control when there is malfunction in both rear wheels.
*4
: The light will go out when engine coolant temperature rises.
*5
: When engine coolant temperature is 0° ° ° ° C {32° ° ° ° F} or less, and TCS operation is inhibited by PCM. When engine
coolant temperature rises and TCS OFF light goes out, the system is normal.
*6
: If a malfunction was detected in the previous driving mode, the light remains illuminated until the system is
verified to be normal when the vehicle is driven at a speed of 10 km/h {6.2 mph} or more.
*7
: The warning light does not illuminates only during stability control solenoid valve or traction switch solenoid
valve off stuck malfunction.
*8
: The warning light illuminates during rear solenoid valves off stuck malfunction.
*9
: Control dose not stop during stability control solenoid valves or traction switch solenoid valve off stuck
malfunction.
*10
: Control does not stop during each solenoid valves (ecept rear inlet solenoid valve) off stuck malfunction.
*11
: The light will go out when the failure is solved.
*12
: If malfunction is related to CAN, light does not illuminate.
*13
: If malfunction is related to CAN, system does not stop.
*14
: Engine TCS is only available
*15
: Engine TCS is only available when pressure reduction inoperation is detected.
*16
: If malfunction is related to combine sensor 0 point adjustment or configuration, light dose not illuminate.
*17
: If malfunction is related to combine sensor 0 point adjustment or configuration, system dose not stop.
*18
: If the module does not configurated, light flashes.
*19
: When engine speed malfunction is detected, brake TCS is only available.
*20
: When engine is mismatch installed, the light does not illuminate.
*21
: When engine is mismatch installed, the system does not stop.
*22
: If malfunction is related to CAN (engine speed), the light illuminates.
*23
: When engine speeed signal has malfunction, only brake DSC is available.
*24
: When engine control system has malfunction, only brake TCS is available.
*25
: When engine control system has malfunction, only brake DSC is available.
ON-BOARD DIAGNOSTIC
P
P–21