Preparing For Embroidery; Attaching The Module - Bernina 780 User Manual

Preparing for embroidery

Preparing for embroidery

Attaching the Module

1 2
1
1 2 2
136
2
1
033804.52.04_2013-09_Manual_B780_EN
ATTENTION!
The slide-on table must not be attached while the embroidery
module is being attached or removed.
When attaching the embroidery module ensure that all the units
are on the same even surface!
The embroidery computer may run at high speeds when
embroidering. Therefore the two units must be placed on a
stable surface or the motor speed reduced when
embroidering.
Make sure that there is enough space around the sewing
computer and embroidery module to allow the unimpeded
movement of the embroidery arm! Always separate the sewing
computer and the embroidery module from one another before
transporting – do not transport!
Connecting the module to the sewing computer
⦁ lift the embroidery module on the left and
⦁ carefully slide it from left to right into the sewing computer connection
Removing the module from the sewing computer
⦁
lift the embroidery module on the left and carefully pull out and off to the left
Attach the slide-on table
The slide-on table can only be attached with the embroidery module
arm to the far left. If necessary, use the «Park Module» function to
move it, see page 150.