Bsr Function Deactivation - Bernina 780 User Manual

BSR
110
activating BSr Sewing function
1st option:
BSR-Function via the foot control
⦁ plug in the foot control
⦁ press the foot control
►
presser foot is lowered
⦁ press the foot control again
►
BSR mode starts
►
a red light appears on the presser foot
⦁
press foot control while sewing
̶ the speed of the sewing computer is regulated by the movement of the
fabric
⦁
release the foot control
►
BSR mode is stopped
2nd option:
BSR-Function via «Start/Stop»-button
⦁
press «Start/Stop»-button
►
presser foot is lowered
⦁ press «Start/Stop»-button again
►
BSR mode starts
►
a red light appears on the presser foot
̶ the speed of the sewing computer is regulated by the movement of the
fabric
⦁ press «Start/Stop»-button again
►
BSR mode is stopped
Deactivating BSr Sewing function by using «Start/Stop»-button
mode 1
If the fabric is not moved for approx. 7 seconds, the BSR mode is deactivated
and the red light on the presser foot goes off.
mode 2
If the stitching process is ended by no longer moving the fabric, one additional
stitch is made, depending on the needle position. The sewing computer always
stops with needle up, even if the arrow on the «BSR»-Display points down.
Holding the work
⦁
hold the work with both hands like an embroidery frame, close to the
presser foot
̶ abrupt movements (slowing down resp. speeding up) can result in slightly
too short or too long stitches
̶ continuous movement (no abrupt movements) will provide best results
̶ do not pivot the fabric while sewing
Quilt gloves with rubber fingertips will help when guiding the work.
application example:
̶ BSR with zig-zag No. 2
̶ zig-zag can be used for thread painting
̶ areas can be filled and therefore forms or pictures can be created

BSr function deactivation

⦁
pull out the plug of the BSR presser foot connection cable on the sewing
computer
⦁
remove the BSR foot
033804.52.04_2013-09_Manual_B780_EN