Table of Contents
Advertisement
1. OPERATIONAL OVERVIEW
1.7.1
How to operate the buttons on the InstantAccess bar
The InstantAccess bar has three types of buttons: toggle button, drop-down list button,
and slider bar button. (The MOB and Capture buttons are special buttons.) The but-
tons can be operated with the trackball module or the InstantAccess knob. This sec-
tion shows you how to use the InstantAccess knob.
Toggle button
PUSH
1. Push the InstantAccess knob to enable its use with the InstantAccess bar.
2. Rotate the InstantAccess knob to select a button. The background color of the
button selected is light-blue.
3. Do one of the following depending on button type.
1) Toggle button: Push the knob to select setting.
2) Drop-down list button or slider bar: Rotate the knob to select an item or ad-
just the slider bar. Push the knob to confirm your selection.
Note: You can use the ESC key to go back one step in the current operating
sequence.
1.8
Sensor Information, Datum Box
The Sensor, datum information box displays
the sensor data and the name of the datum in
use. The sensor indications and names are
colored according to sensor state. See the ta-
ble on the next page.
• HDG: Heading and its source.
• SPD: Longitudinal speed and its source.
The direction of transverse speed is indi-
cated with arrows,
• COG: Course over ground and its source.
• SOG: Speed over ground and its source.
• POSN: Latitude and longitude position of
own ship and its source.
• Datum: Chart datum (WGS84, WGS72,
etc.) in use. No datum appears when there
is no datum sentence.
1-16
Drop-down list button
A drop-down list button provides the
functions related to the label on the
button. This type of button is identi-
fied by the triangle at the bottom-right
corner of the button.
[Palette]
button
Palette list
, Starboard,
, Port.
Slider bar button
Note: The position source shall meet
the requirements of IMO MSC.112(73).
Advertisement
Table of Contents
Troubleshooting
