How To Preset Antenna And Display Combinations - Furuno FCR-21x9-BB Operator's Manual

2. RADAR, CHART RADAR OPERATION
ANT 1 : X-BAND
25UP Main Top
ANT 2 : S-BAND
30UP Main 2nd
ANT 3 : X-BAND
12 Fore
ANT 4 : X-BAND
12 Aft
2.28.2

How to preset antenna and display combinations

You can preset the antenna and display combinations for each antenna and display
in the radar system. As an example, the procedure below shows how to select the no.
1 antenna unit for the no. 2 display unit.
1. Open the menu then select the [8 INITIAL SETTING] and [5 ANT SELECT]
menus.
2. Select the display unit for which to select an antenna (at the next step). For exam-
ple, select [DISP2] to select the no. 2 display unit.
3. Select [ANT1] and [M].
4. Repeat steps 2 and 3 to set other display and antenna combinations.
5. Click [STORE INT-SW] and select [YES] to save your selections.
6. Close the menu.
2-40
Using the information displayed in this example the antenna system configuration would
look something like this.
ANT1 ANT2
DISP1 DISP2
HUB-3000
ANT3 ANT4
← Antenna Unit
← Radar Processor Unit
DISP3 DISP4 ← Processor Unit