Code Setting Mode; Engine Control; Inspection And Repair Of Antitheft Controller System; Check Remote Control - Chery QQ Service Manual

will automatically work to close the glass windows one by one if the glass window is
not closed.
4.

Code setting mode

Turn on the ignition switch IGN ON/OFF for two times within 7 second and push
IGN at ON position.
LED flashes quickly for 3 seconds;
LED will pause 1 second after the above response;
When the flash time of LED equals to PIN CODE (PIN CODE =1), set the switch at
IGN OFF;
When the ignition switch is set at IGN ON, press the first key to set the system;
Set the switch at IGN OFF;
When IGN is at OFF position for 10 seconds, it means the system has quit the code
setting mode or you can immediately turn the IGN at ON position to enter
software-switching application.
5.

Engine control

When the ignition switch is set at ST position, the power is supplied through the fuse to
BCM No. 2 Foot. The starting relay is embedded in the BCM computer. When the
antitheft function fails, the starting relay controls operation of the engine.
IV. Inspection and Repair of Antitheft Controller System

1. Check remote control

1) When you press down Unlock or Lock keys, central door lock fails to work. Firstly,
remote control should be checked whether LED indicator light flashes or not when you
press the button. If it flashes, something is wrong with antitheft computer, which will be
then maintained or replaced. Otherwise, something is wrong with remote control. Then
the battery should be checked. If there is power in the battery, remote control fails and
shall be replaced. If out of power, the battery should be replaced.
2) Replace the battery in remote control. Unclench remote control first, and then
change battery as shown in the figure below.
Chery QQ Service Manual
- 82 -
BCM Computer Control System