High Beam Indicator; Snow Mode Indicator - Chery SQR7240T User Manual

When ignition switch is turned on, the
warning indicator is ON, and electrical
control system of engine will make a
self-check of electric throttle. If the system
has no faults, the indicator shall be OFF
when the self-check is over. If the
indicator keeps ON, check the electric
throttle necessarily.
If during running, the indicator is ON, it is
shown that the electric throttle of engine
has a fault. Please turn to Chery chartered
service station for examination & repair as
quickly as possible.
Automatic transmission
fault indicator (
When automatic transmission circuit has a
fault, automatic transmission
indicator should be constantly ON if
ignition switch is in the position of ON, no
matter whether the vehicle is on the run.
Stop driving it and contact Chery
chartered service station immediately.
Automatic
indicator (
When ignition switch is in the position of
ON, press down the ON button of cruising
controller, and the automatic cursing
indicator in the dashboard blinks to
suggest initiation of pre-cruising; if during
)
running, automatic cruising system works,
the indicator keeps constantly ON to show
that the system is at work.
Snow
（ ）
fault
When ignition switch is in the position of
ON, press down the snow mode button
near the gear shift operating rod, and the
cruising
)
mode indicator
Instrument Panel
snow mode indicator in the dashboard will
be ON. Start the engine and push the
operating rod at the position D (Drive),
and the speed variator starts at 2
drive your car (it is suggested that the
mode be selected when starting is done
from such roads as cladded by snow with
low attachment coefficient). Then, press
down the snow mode button, and the snow
mode indicator in the dashboard is OFF;
the system exits from the snow mode.

High beam indicator

The indicator will be ON when high beam
is used or front headlight blinks.
nd
gear to