Mechanical Transmission - Engagement Position Sensor - Chery QQ Service Manual

Tightening torque (unit: DAN.M)
Power on position sensor bolt
Drive mechanism module nut
Lifting ring fixing nut
High-pressure pipeline coupler
Energy storage
Remarks:
Before maintaining
mechanical transmission, use a special repair tool
to remove the energy storage (refer to the section
of "ENERGY STORAGE").
When removing the engagement position sensor, it
is unnecessary to remove the drive mechanism
module.
Removal:
Remove the potentiometer for accelerator and
footbrake and its support.
PDF created with pdfFactory Pro trial version
CHERY SQR7080 EZ Drive SERVICE MANUAL
MECHANICAL TRANSMISSION
– ENGAGEMENT POSITION SENSOR
0.4
2.1
2.1
1.4
4
the entire automated
www.pdffactory.com
Disconnect the engagement position connector (A)
Remove the engagement position sensor (A)
Remounting:
Carry out the remounting procedure that is opposite
to the removal procedure.
Perform the corresponding test by using a special
tool. (Refer to the page 21-36 of section "special
requirements on change of system parts and
components of KIT electrically controlled hydraulic
system")
Oil filling into oil tank
The mark shown on the oil tank is the lowest
standard.
Carry out the energy storage removal procedure.
Make sure that the oil level is 32 to 38 mm higher
than the lowest mark line.
Important tip:
The oil level will be at the position indicated by the
mark line (MIN) when the energy storage has been
fully inflated (15 seconds after ignition).