Chery QQ Service Manual page 567

Remove the handle of this hydraulic unit.
Fix the hydraulic unit to the transmission by
tightening the fixing bolts.
Place back the control shaft cover (lubrication
washer).
It is easy to remount the hydraulic unit onto the
transmission and you need only to carry out the
procedure opposite to the removal procedure.
Remove the outside washer for oil tank cap.
Fill the ELF RENAULT MATIC D3 SYN
DEXRON oil to the degree that the oil level is 32 to
38 mm higher than the lowest mark line.
Perform the corresponding test by using a special
tool. (Refer
REQUIREMENTS ON CHANGE OF SYSTEM
PARTS AND COMPONENTS")
PDF created with pdfFactory Pro trial version
MECHANICAL TRANSMISSION
– ELECTRONICALLY CONTROLLED HYDRAULIC UNIT
"SPECIAL
to the section
CHERY SQR7080 EZ Drive SERVICE MANUAL
Oil filling into oil tank
The mark shown on the oil tank is the lowest
standard.
Carry out the energy storage removal procedure.
Make sure that the oil level is 32 to 38 mm higher
than the lowest mark line.
Important tip:
The oil level will be at the position indicated by the
mark line (MIN) when the energy storage has been
fully inflated (15 seconds after ignition).
www.pdffactory.com