Chery QQ Service Manual page 466

Chery QQ Service Manual
(3) Unfasten 2 fixed bolts on the trunk
lock.
(4) Take out the lock assembly.
Adjust the trunk door
1. Adjust the trunk door
(1)Loosen bolts, and adjust the door in forward/backward, and left/right directions.
(2)Increase or decrease the amount of washers between hinge and trunk door to adjust
the front end in upward or downward directions.
Torque: 11.5 Newton-meter (115 kg-cm, 8.3 pound-foot)
2.Adjust the lock crossbar
Gently knock the crossbar with hammer or bronze bar for adjustment.
Torque: 5.4 N.m (55 kg-cm, 48 pound-inch)
Replace the trunk door support
1. Remove the trunk door support
(1)Unfasten the support bolts out of trunk door hinge.
(2)Turn the back end of the support downward, and take the support out of bracket.
2. Replace the trunk door support
Note: Be careful of when operating the support.
(1)There is compressed air in the support cylinder. Do not disassemble the support.
(2)If the support is to be replaced, drill a small hole with diameter of 2.0-3.0 m
0.079-0.118 inch on the shadow area of cylinder to fully release compressure, then
abandon it.
- 230 –Chery Automobile Co.,Ltd