S-Video/Video Connections - JVC HD-DH5US Instructions Manual

74
EN
S-VIDEO/VIDEO
Connections
Various connection for editing tapes
The following three methods can be used for editing
tapes.
•
VHS to S-VHS editing (VIDEO-VIDEO connection):
Although the picture quality is inherently limited by the
original VHS quality, the edited tape has better picture
quality than those made by VHS-to-VHS editing.
•
S-VHS to VHS editing (VIDEO-VIDEO connection):
Since the original source is recorded in S-VHS mode, the
edited tape has better picture quality than those made by
VHS-to-VHS editing.
•
S-VHS to S-VHS editing (S-VIDEO connection):
Original picture quality of S-VHS made can be duplicated
with minimal picture degradation. This is the best editing
method you can use on S-VHS VCRs.
A You can use a camcorder as the playback device
and your VCR as the recording VCR.
This VCR (for recording)
To [AUDIO]
input
To [S-VIDEO] input
Audio cable
(supplied)
S-video cable
(supplied)
To S-video
output
To rear panel
[REMOTE PAUSE/AV
COMPULINK]
Mini-plug cable (not
supplied)
(JVC camcorder only)
To Audio
output
To EDIT
DV camcorder
(for playback)
B You can use your VCR as the playback or
recording VCR.
E.g. When using this VCR as the recording VCR
This VCR (for recording)
To AUDIO
output
Another VCR (for playback)
NOTE:
When using this VCR as the playback VCR,
During playback, if the images cannot be displayed on the
TV, press [HDMI] on the front panel to turn off the [HDMI]
LED and set "TV OUTPUT 2" to "ALLto480i" (
In event when even the main menu screen cannot be
displayed on the TV when [MENU] is pressed, power off this
VCR, press and hold [PAUSE (
then power on the VCR again.
A
Make connections
A Connection with the camcorder
Connect an audio/S-video cable between the
camcorder's audio/S-video output connectors
and your VCR's [AUDIO/S VIDEO] input
connectors.
•
When the JVC camcorder is equipped with
the Master Edit Control, you can control the
VCR from the camcorder. Connect the mini-
plug cable (not supplied with this VCR) as
illustrated on the left.
•
When using a camcorder with a monaural
output, connect the audio output connector
on the camcorder to the [AUDIO L] input
connector on this VCR.
NOTE:
If the camcorder does not have S-video output
connector, use a video cable.
EDITING (cont.)
To [S-VIDEO
To [AUDIO
INPUT]
INPUT]
Audio cable
S-video cable
(supplied)
(supplied)
To S VIDEO
output
A
page 65).
W
)] for more than 5 seconds,