Other Problems - JVC HD-DH5US Instructions Manual

82
EN
VIDEO NAVIGATION
SYMPTOM
2. The VCR cannot search for the
desired program.
3. "MEMORY FULL" appears on the
screen when you try to start
recording.
4. The information data for Video
Navigation is not registered.

OTHER PROBLEMS

SYMPTOM
1. When scanning channels, some
of them are skipped over.
2. The channel cannot be changed.
3. The Remote will not operate your
TV or cable box or DBS receiver.
4. Even though Auto or Semiauto
Clock Set has been performed,
the clock is incorrect.
5. "PM" blinks on the front display
panel.
6. The subtitles and the menu screen
are overlapped.
7. The subtitles cannot be displayed. • You are viewing the program in EE
POSSIBLE CAUSE
• Two (or more) tape numbers are
recorded on one tape.
• The inserted program is not
recorded on this VCR.
• The VCR's memory for Video
Navigation is fully recorded.
• The VCR's memory for Video
Navigation is fully recorded.
• "NAVIGATION" is set to "OFF".
• The recording time is not enough.
POSSIBLE CAUSE
• Those channels have been preset to
be skipped.
• Recording is in progress.
• The brand codes are set incorrectly. Reset the correct brand codes
• The clock setting data received
from the host channel is incorrect.
• The VCR do not work properly.
• The subtitle display on the TV is set
to on.
mode through the HDMI
connection.
TROUBLESHOOTING (cont.)
CORRECTIVE ACTION
Video Navigation cannot work
correctly on a tape if it has more than
one tape number. If this happens,
fast-forward the tape up to its end,
eject it, and try it again.
It is impossible to search the desired
program which is not recorded on
this VCR using Video Navigation.
Check the remaining memory
(A page 61). If it is full, delete
unnecessary Video Navigation
information (A pages 60, 61).
Check the remaining memory
(A page 61). If it is full, delete
unnecessary Video Navigation
information (A pages 60, 61).
Set "NAVIGATION" to "ON"
(A page 52).
For details on the recording time for
Video Navigation, refer to 'NOTES'
on page 51.
CORRECTIVE ACTION
If you need the skipped channels,
restore them (A page 21).
Press [PAUSE (W)] to pause the
recording, change channels, then
press [PLAY (I)] to resume recording.
(A pages 76, 77).
Select a different host channel during
Semiauto Clock Set (A page 18), or
perform Manual Clock Set
(A page 19).
Unplug the AC power plug once,
then plug it again.
Set it to off.
Make use of the analog connection
(Component Video, S-Video or
Video), and set "TV OUTPUT 2" to
"ALLto480i" (A page 65). However,
if the picture is of 480p image format,
the subtitles cannot be displayed.