JVC HD-DH5US Instructions Manual page 75

Connection with the VCR
B
Connect an audio/S-video cable between the
playback VCR's audio/S-video output
connectors and the recording VCR's [AUDIO/
S VIDEO INPUT] connectors.
•
When using this VCR as the recording VCR,
connect this VCR's [AUDIO/S VIDEO
INPUT] connectors to the audio/S-video
output connectors on the other VCR.
If the playback VCR is monaural, connect
the audio output connector on the playback
VCR to the [AUDIO L INPUT] connector on
this VCR.
NOTE:
If another VCR does not have S-video input/output
connectors, use a video cable.
B
Load a cassette
Insert the cassette to be recorded on into this VCR
(for recording).
C
Select input location on this VCR
[L-1] or [L-2] — when connecting the device to
[F-1] — when connecting the device to
On the front panel:
Press [CHANNEL +/–].
On the Remote:
Press the 'Number' key [0 (AUX)] or
[TV/VCR CH +/–].
NOTE:
When using this VCR as the recording VCR, set the
video input terminal setting correctly. This setting
selects either the S-Video or composite video (
65).
D
Set recording speed
Press [REC SPEED] to set the tape speed.
Input Source
(Playback device)
D-VHS
Analog
input
S-VHS/VHS
the [AUDIO/VIDEO INPUT] or
[AUDIO/S VIDEO INPUT]
connectors on the rear panel.
the [AUDIO/VIDEO] or
[AUDIO/S VIDEO] input
connectors on the front panel.
A
Selectable Recording Speed
(Recording device: This VCR)
HS, STD, LS3
SP, EP
E
Select video input terminal
Access the "IN/OUT FUNCTION" screen (A
page 65).
When using [S VIDEO] terminal, set "FRONT
AUX F-1" (or "REAR AUX L-1" (or "L-2") if you
use the connectors on the rear) to "S-VIDEO".
When using [VIDEO] terminal, set "FRONT AUX
F-1" (or "REAR AUX L-1" (or "L-2") if you use the
connectors on the rear) to "VIDEO".
F
Set "PICTURE CONTROL" to
"EDIT"
Access the "VIDEO FUNCTION" screen (A page
63).
G
Start playback
Press [PLAY (I)] on the connected device.
NOTE:
If the connected device is equipped with a superimpose/
OSD disable feature then set it to "OFF" before starting
playback.
H
Start recording
On the front panel:
Press [REC (R)].
On the Remote:
Press [REC (R)] and [PLAY (I)] at the same time.
To use a Master Edit Control-equipped JVC
camcorder
A Access the "ADDITIONAL" screen (A page 66),
then set "AV COMPU-LINK" to "OFF" after per-
forming step
•
The REMOTE PAUSE/AV COMPULINK
connector works as a Remote Pause connector
when "AV COMPU-LINK" is set to "OFF".
•
For details, refer to the camcorder's instruction
page
manual.
B Engage the VCR's recording pause mode.
NOTES:
•
Be sure to select "AUTO" for "PICTURE CONTROL" (or
"NORM" when "V. CALIBRATION" is set to "OFF") after you
finish dubbing the tapes (
•
It is impossible to perform dubbing properly only with an
audio cable. Connect also the video or S-video cable.
.
F
A
page 63).
75
EN