Table of Contents
Advertisement
BEFORE YOU START
WARNING
Excessive Weight Hazard
Use two or more people to move and
install washer.
Failure to do so can result in back or
other injury.
NOTE: To avoid floor damage, set the washer
onto cardboard before moving across floor.
REMOVE SHIPPING MATERIALS
Removing the shipping material is necessary
for proper operation. If the shipping material
is not removed, the washer will make exces-
sive noise.
1.
Move the washer to within approximately
3 ft (90 cm) of its final location.
2.
The washer must be in the upright po-
sition and not tilted before removing the
shipping material.
3.
Locate the yellow shipping materials on
the rear of the machine, near the bottom.
Follow the steps for your particular mod-
el, either the one with the straight pow-
er cord and cord restraint or the looped
power cord version.
Straight power cord
Straight power cord
INSTALLATION INSTRUCTIONS
1.
Remove power plug and yellow strap
from machine base to release the rear
leveling system.
2.
Firmly grasp the power cord and pull to
completely remove the power cord, cord
restraint, and pin from the rear panel.
3.
Confirm that the power cord restraint (A),
and pin (B) are removed.
A
A. Power cord restraint
B. Pin
4.
To remove the power cord from the cord
restraint, push the power cord in, press
TAB, and then pull the power cord out.
2-5
B
Hide quick links:
Advertisement
Table of Contents
