Table of Contents
Advertisement
Other medical devices—If you use any other personal medical
device, consult the manufacturer of the device to determine if it
is adequately shielded from external RF energy. Your physician
may be able to help you obtain this information.
In health care facilities—Turn your device off in health care
facilities when instructed. Hospitals and health care facilities
may be using equipment that is sensitive to external RF energy.
Potentially unsafe areas
Posted facilities—Turn your device off in any facility when
posted notices require you to do so.
Aircraft—FCC regulations prohibit using your device on a plane
that is in the air. Turn your device off or switch it to Airplane
Mode before boarding aircraft.
Vehicles—RF signals may affect improperly installed or
inadequately shielded electronic systems in motor vehicles.
Check with the manufacturer of the device to determine if it is
adequately shielded from external RF energy.
Blasting areas—Turn off your device where blasting is in
progress. Observe restrictions, and follow any regulations or
rules.
Potentially explosive atmospheres—Turn off your device
when you are in any area with a potentially explosive
atmosphere. Obey all signs and instructions. Sparks in such
areas could cause an explosion or fire, resulting in bodily injury
or death. Areas with a potentially explosive atmosphere are
often, but not always, clearly marked.
They include:
•
fueling areas such as gas stations
•
below deck on boats
•
transfer or storage facilities for fuel or chemicals
•
vehicles using liquefied petroleum gas, such as propane or
butane
•
areas where the air contains chemicals or particles such as
grain, dust, or metal powders
•
any other area where you would normally be advised to turn
off your vehicle engine
4
Use with Care
Use only in normal position (to ear). Avoid dropping, hitting,
bending, or sitting on the device.
Avoid Magnetic Environments
Keep the device away from magnets which can cause improper
functioning of the device.
Keep Your Device Dry
Keep the device dry. Damage can result if the device gets wet.
Water damage is not covered under warranty.
Resetting the Device
If the screen seems frozen and the keypad does not respond to
key presses, reset the device by completing the following steps:
1. Remove the battery cover.
2. Remove and replace the battery.
If the problem persists, return the device to the dealer for
service.
Accessories
Kyocera makes no representation or warranty with regard to
accessories other than those originally packaged with the
device. Please check with the manufacturer of any third party
accessories as to compatibility and safety.
Radio Frequency (RF) Energy
Your device is a radio transmitter and receiver. When it is on, it
receives and sends out RF energy. Your service provider's
network controls the power of the RF signal. This power level
can range from 0.006 to 0.6 watts.
In August 1996, the U.S. Federal Communications Commission
(FCC) adopted RF exposure guidelines with safety levels for
hand-held wireless devices. These guidelines are consistent
with the safety standards previously set by both U.S. and
international standards bodies in the following reports:
•
ANSI C95.1 (American National Standards Institute, 1992)
•
NCRP Report 86 (National Council on Radiation Protection
and Measurements, 1986)
Advertisement
Table of Contents
