NEC Xn120 Getting Started Manual page 26

Configure the Xn120
Program 22-04-01
2
The telephones are placed into
ring groups (IRG's).
3 Program 20-07-01
Turn on the day/night mode
option.
Assign a key to each
4
mode
Choose a telephone that will
be able to change the
day/night mode.
! Exit Configuration Mode.
The keys are set at the
telephone itself, not within
Xn120 configuration mode.
See also:
Outgoing Exchange Line Access to give a telephone a dedicated line for outgoing calls.
26
Default Setting:
Telephone number 200 is a member of IRG number 1.
Press HOLD to
22-04-01 INC Gr1
select the next
Memb.01=
member
Ø Enter the new telephone number, you can overwrite the
current entry.
Ø To remove an entry press CLEAR.
Ø Press HOLD to confirm the entry and step to the next member.
Ø Press DC several times when you are done to return to the
Program Mode.
Ø (Press SPK to save changes and exit if you are finished).
Default Setting:
Day/night modes can not be changed by any telephones.
Ø Enter 1 to enable the option, you can overwrite the current
entry.
Ø Press HOLD to confirm the entry.
Ø Press DC several times when you are done to return to the
Program Mode.
Ø (Press SPK to save changes and exit if you are finished).
Default Setting:
There are no keys set to day/night modes on any of the telephones.
1. At the telephone that you want to be able to change the
day/night mode press SPK.
2. Dial service code 851
3. Press the Programmable Function Key you want to set (its
current setting is shown if you have an LCD display). Use
one of the block of 10 keys for your day/night mode keys.
4. Dial 09 followed by the mode number 1 to 8.
1 = Day
2 = Night 1
3 = Mid-Night 1
4 = Rest 1
5. Repeat steps 3. and 4. for further keys/modes.
200
20-07-01 F-Cls 1
SW Man NT serv 0
5 = Day 2
6 = Night 2
7 = Mid-Night 2
8 = Rest 2
Xn120 Getting Started Guide
Press Vol p q
to select the
IRG number
Enter 1 to
enable
Day/night mode
option