NEC Xn120 Getting Started Manual page 10

Wall Mount the Xn120 system
2
Remove the sub cover of the
Xn120.
Hook the Xn120 onto the wall
mount screws.
Tighten the lower screws to
secure the unit to the wall.
3 Earth the Xn120 system.
Caution: If this cable is not
installed or requires
disconnection, then the
telecommunication network
connection(s), CO and/or
ISDN, must be disconnected
first from the Xn120.
10
Push
Fasten lower
two screws
Important. The system must have a permanent Earth Ground
connection to a verified Earth point using a minimum of 2.5mm
green/yellow cable.
The Earth connection must have no other purpose than connecting to
the Xn120 unit.
Slide
Hook
onto
screws
2
The Earth point is located
on the left side under the
sub cover.
Xn120 Getting Started Guide