Kyocera ECOSYS FS-4300DN Service Manual page 69

Code Contents
0170 Billing counting error
A checksum error is detected
in the main and engine
backup memories for the bill-
ing counters.
0190 Backup memory device
error (engine PWB)
0800 Image processing error
JAM010x is detected twice.
0840 Faults of RTC
The time is judged to go back
based on the comparison of
the RTC time and the current
time or five years or more
have passed.
1010 Lift motor error
(60/50/45 ppm model only)
After cassette 1 is inserted, lift
sensor does not turn on within
10 s. This error is detected
four times successively.
Causes
Data damage of Contact the Service Administrative Division.
EEPROM.
Defective PWB. Replace the main PWB or the engine PWB
and check for correct operation (see page 1-
5-22, 1-5-22).
Defective engine Replace the engine PWB and check for cor-
PWB. rect operation (see page 1-5-22).
Defective main Replace the main PWB and check for cor-
PWB. rect operations page 1-5-22).
The battery is dis- Check visually and remedy if necessary
connected from the
main PWB.
Defective main Replace the main PWB and check for cor-
PWB. rect operation (see page 1-5-22).
Defective bottom Check to see if the bottom plate can move
plate elevation smoothly and repair it if any problem is
mechanism in the found.
cassette.
Defective connec- Reinsert the connector. Also check for conti-
tor cable or poor nuity within the connector cable. If none,
contact in the con- replace the cable.
nector.
Lift motor and engine PWB (YC13)
Defective drive Check if the gears rotate smoothly. If not,
transmission sys- grease the bushes and gears. Check for
tem of the lift broken gears and replace if any.
motor.
Defective lift motor. Replace the lift motor.
Defective engine Replace the engine PWB and check for cor-
PWB. rect operation (see page 1-5-22).
1-4-9
2LV/2L1/2L2/2MS/2MT
Check procedures/
corrective measures