Selecting A Bootable Device - DEC 4000 Model 200 Operation Manual

Figure 2–5: Selecting a Bootable Device
KA660-A Vn.n VMB n.n
Performing normal system tests.
95..94..93..92..91..90..89..88..87..86..85..84..83..82..81..80..
79..78..77..76..75..74..73..72..71..70..69..68..67..66..65..64..
63..62..61..60..59..58..57..56..55..54..53..52..51..50..49..48..
47..46..45..44..43..42..41..40..39..38..37..36..35..34..33..32..
31..30..29..28..27..26..25..24..23..22..21..20..19..18..17..16..
15..14..13..12..11..10..09..08..07..06..05..04..03..
Tests completed.
Loading system software.
No default boot device has been specified.
Available devices.
-DIA0 (RF72)
-DIA1 (RF72)
-MUA0 (TK70)
-EZA0 (08-00-2B-06-10-42)
Device? [EZA0]:DIA0
(BOOT/R5:0 DIA0)
2..
-DIA0
1..0..
Changing the Boot Device
Once a boot device is identified, the system autoboots from that device each
time you turn it on, until you do one of the following:
• Change the setting of the Break Enable/Disable switch to enable (up,
dot inside the circle). If you do so, the system will not autoboot but
will enter console mode after completing self-tests (assuming you have
not defined a halt action of
HALT console command). Refer to Section 2.4.2 for instructions on
booting from console mode.
• Change the boot device by using the SET BOOT command.
or
REBOOT RESTART_REBOOT
Operating the System
using the SET
2–9