DEC 4000 Model 200 Operation Manual page 121

2. Boot standalone BACKUP as described in Section C.1.2 or Section C.1.4.
3. If you have a backup tape cartridge, make sure it is write protected.
Insert it in the drive.
4. Enter the BACKUP command in one of the following formats:
$ BACKUP/IMAGE/VERIFY source_drive: target_drive:
$ BACKUP/IMAGE/VERIFY source_drive:-
-$ saveset.BCK/SAV/REWIND target_drive:
where:
•
source_drive
Use the device name of the drive holding the backup disk or tape
cartridge.
•
target_drive
holding the system disk.
•
saveset.BCK
cartridge.
For example:
$ BACKUP/IMAGE/VERIFY DIA0: DIA1:
The following example uses the BACKUP command to restore the
system disk from a backup tape cartridge:
$ BACKUP/IMAGE/VERIFY-
-$ MUA0:APR_19_1991.BCK/SAV/REWIND DIA0:
5. The system displays the following message:
%BACKUP-I-STARTVERIFY, starting verification pass
If you are backing up to a disk or if your saveset fits on one tape, proceed
to step 7.
6. If you have more than one backup tape cartridge, the system displays
the following message:
%BACKUP-I-RESUME, Resuming operation on volume 2
%BACKUP-I-READYWRITE, Mount volume 2 on _MUA0: for reading
Enter "YES" when ready:
Remove the backup tape cartridge from the drive. Insert the next
backup tape cartridge in the drive, enter Y (for Yes) and press Return.
Each time you receive a mount request, repeat this step.
C–10 VAX 4000 Model 200 (BA430) Operation
is the location of the files that you want to restore.
is the destination. Use the device name of the drive
is the name of the saveset, if you have a backup tape
Return
Return
Return
Return
Return
Return