Setting Node Name; Setting System Id - DEC 4000 Model 200 Operation Manual

B.3.4 Setting Node Name
After entering the DUP driver utility for a specified device, you can examine
and set the node name for the device as follows:
1. At the prompt, enter
PARAMS>
the ISE to which you are currently connected.
2. Enter
SET NODENAME SYSDSK
name of up to eight characters).
3. Enter
SHOW NODENAME
Example B–7 shows the steps for changing the node name of a specified
device from the factory-supplied name to SYSDSK.
Example B–7: Changing a Node Name for a Specified Device
PARAMS>SHOW NODENAME
Parameter Current
--------- ----------------
NODENAME R7CZZC
PARAMS>SET NODENAME SYSDSK
PARAMS>SHOW NODENAME
Parameter Current
--------- ----------------
NODENAME SYSDSK
B.3.5 Setting System ID
NOTE: This parameter is modified only when replacing a device. Only
Digital service representatives and qualified self-maintenance customers
should remove devices. All parameters for the replacement device should
be programmed to match those of the original device.
After entering the DUP driver utility for a specified device, you can examine
and set the system ID for the device as follows:
1. At the prompt, enter
PARAMS>
the device to which you are currently connected.
2. Enter
SET SYSTEMID System ID
system ID).
3. Enter
SHOW SYSTEMID
B–12 VAX 4000 Model 200 (BA430) Operation
SHOW NODENAME
(or enter the desired alphanumeric node
to verify the new node name.
Default
----------------
RF31
Default
----------------
RF31
SHOW SYSTEMID
(enter the desired serial number-based
to verify the new system ID.
to check the node name of
Type Radix
-------- -----
String Ascii
Type Radix
-------- -----
String Ascii
to check the system ID of
B
B