DEC 4000 Model 200 Operation Manual page 119

•
volume_label
drive. If the tape has been initialized already, use the same volume
label that was assigned by the INITIALIZE command. If the tape
has not been initialized, you can assign a volume label at this time.
The volume label cannot have more than six characters.
The following example uses the BACKUP command to make a backup
disk. You can use a backup disk as the system disk:
$ BACKUP/IMAGE/VERIFY DIA0: DIA1
The following example uses the BACKUP command to make a backup
tape cartridge. The contents of the backup tape cartridge must be
restored to a disk before you can use them. For more information,
see Section C.3.
$ BACKUP/IMAGE/VERIFY DIA0: MUA0:-
-$ APR_19_1991.BCK/LABEL=19APRF/REWIND
6. The system displays the following message:
%BACKUP-I-STARTVERIFY, starting verification pass
7. If you are backing up the system disk to another disk, proceed to step
8.
If you are backing up your system disk to a tape cartridge and the
contents of the system disk fit on one tape cartridge, remove the backup
tape cartridge from the drive. Label the tape COMPLETE SYSTEM
BACKUP, number it, and include the date. Proceed to step 8.
If you are backing up your system disk to a tape cartridge and the
system disk contains more data than one tape cartridge can store, the
system displays the following messages:
%BACKUP-I-RESUME, Resuming operation on volume 2
%BACKUP-I-READYWRITE, Mount volume 2 on _MUA0: for writing
Enter "YES" when ready:
Do the following:
a. Remove the backup tape cartridge from the drive.
b. Label the tape COMPLETE SYSTEM BACKUP, number it, and
include the date.
c. Write-protect the tape cartridge.
d. Write-enable another scratch tape cartridge and insert it in the
drive.
C–8 VAX 4000 Model 200 (BA430) Operation
is the volume label of the tape cartridge in the tape
Return
Return
Return