Table of Contents
Advertisement
Section 3 ► Operation
Channel
Channel
to select a specific source setup (channel) defined and stored in projector memory.
Press
Channel
Once you enter a two-digit channel number (or, if there is a list displayed, highlight it and press
), the display will automatically change and update according to the numerous setup
parameters defined for that channel. Note that a new channel is automatically created if you
adjust an image from a new source.
noTe: Channel (
Display Channel List option is enabled in the Menu Preferences menu. You can choose to
use a scrollable list of channels when you press
channel number "blind", i.e., without on-screen feedback. See Menu Preferences later in this
section.
InPUT 1
Input 1
Press
Input 1
to display from the data or video input source connected to BNCs labeled InPUT
1.
InPUT 2
Input 2
Press
to display from the DVI source connected to InPUT 2.
Input 2
InPUT 3
Input 3
Press
to display from the composite video source connected to InPUT 3.
Input 3
InPUT 4
Input 4
Press
to display from the S-Video source connected to InPUT 4.
Input 4
InPUT 5
Input 5
Press
to display from the InPUT 5 interface module installed in the Option 1 slot.
Input 5
noTe: If you have the optional Dual SD/HD-SDI Module installed and there are two inputs
connected here, the second input (B) is considered INPUT 7. If you are using the built-in keypad
or the remote keypad, press INPUT 5 to access INPUT 7 as follows:
•
While displaying from
•
While displaying from any input other than the Dual SD/HD-SDI Module, press
switches to either INPUT 5 or INPUT 7, depending on which of the Dual SD/HD-SDI Module
inputs (A or B) was last used. Press
Module input.
InPUT 6
Input 6
Press
to display from the INPUT 6 interface module installed in the Option 2 slot.
Input 6
noTe: If you have the optional Dual SD/HD-SDI Module installed and there are two inputs
connected here, the second input (B) is considered INPUT 8. If you are using the built-in keypad
or the remote keypad, press INPUT 6 to access INPUT 8 as follows:
•
While displaying from
•
While displaying from any input other than the Dual SD/HD-SDI Module, press
switches to either INPUT 5 or INPUT 8, depending on which of the Dual SD/HD-SDI Module
inputs (A or B) was last used. Press
Module input.
) key behavior during a presentation depends on whether or not the
Channel
INPUT 5, press
Input 5
Input 5
INPUT 6, press
Input 5
Input 5
3-6
, or you may prefer to enter the desired
Channel
again. This switches to INPUT 7.
again to display from the other Dual SD/HD-SDI
again. This switches to INPUT 8.
again to display from the other Dual SD/HD-SDI
. This
Input 5
, which
Input 5
Advertisement
Table of Contents
