Table of Contents
Advertisement
3.48 faD
fade Time
3.49 fCs
focus
3.50 fIl
Input filter
3.51 fle
frame lock enable
3.52 fMT
2/3 Pull Down Threshold
examples:
noTe: The 65535 signifies the port address of the controller receiving the message.
SYNC no longer responding
Attempt to delete the current source (65535 00030ERR 002 "System Warning: The current
(BDR38900)
(BLB 25 25)
(ASR S10)
(ASR S10 1)
(CON 45) with no source
(&con 64 250)
(ABC?)
faD faDe TIMe
Use FAD to set the time for dissolving one display image into the next (0=seamless, 100=1
second). Or, if using v1.0 software, FAD sets the time for fading to black and then to the new
display image.
fCs foCUs
The FCS adjusts lens focus on projectors having a motorized lens mount, and requires keypad
emulation.
examples:
(FCS K3)
(FCS K2)
(FCS K0)
To "nudge" the focus a minimum amount, script in a delay between (FCS K3) and (FCS K0).
Depending on your application, a delay of at least 20-30 milliseconds may be sufficient.
fIl InPUT fIlTeR
Use FIL to force an internal filter for HDTV (1), SDTV (2), EDTV (3), Graphics/RGB (4) or to turn
the automatic filtering feature off (0). This automatic filter is for analog sources only.
fle fRaMe loCK enable
Use FLE to define how the projector controls the output frame timing based on the input signal.
Use the following parameters to achieve the desired output frame timing.
P1 = 0: Rate Matched – the output runs at close to the input frequency but is not locked to it so
the output will drift in phase relative to the output.
P1 = 1: Locked – if possible the output image is phase locked to the input frames
P1 = 2: Free Run – the output runs at 60Hz frame rate
For older versions of software (v1.1 and earlier) this control is a checkbox to enable a "Locked"
output. When unchecked the output is "Frame Matched".
fMT 2/3 PUll DoWn ThResholD
Use FMT to adjust the threshold (0-255) at which the projector will consider an incoming video
signal as film vs. video.
B-21
(65535 00030ERR 001 "System Error: SYNC no longer
responding")
source cannot be deleted")
(65535 00030ERR 003 "BDR: Invalid parameter 1")
(65535 00030ERR 004 "BLB: Too many parameters")
(65535 00030ERR 005 "ASR: Too few parameters")
(65535 00030ERR 006 "ASR: Source does not exist")
(65535 00030ERR 007 "CON: Could not be executed")
(65535 00030ERR 008 "CON: Checksum Error")
(65535 00030ERR 009 "ABC: Unknown request")
–ve Focus direction
+ve Focus direction.
Stop focus adjustment (if not issued, lens movement will continue
until it reaches the end stop).
Appendix B ► Serial Communications
Advertisement
Table of Contents
