Table of Contents
Advertisement
P3 = State/details (opt.)
If P1 = F or f
P1 = F or f
P2 = Number key
If P1 = X or x
P1 = X or x
P2 = Target
examples:
(RTE g 7 H "(GIO 22 P 100)")
(RTE g 7 H "(GIO 22 P 100) (GIO 1 L)")
(RTE G 7 H "(GIO 22 P 100) (GIO 1 L)")
(RTE T 2003/07/09 12:36:45 S "(PWR 1)")
(RTE T 2003/07/09 18:00:00 D "(PWR 0)")
(RTE T 2003/07/09 05:00:00 W "(PWR 0)") = "W" Weekly
(RTE F 3 "(FRZ 1)")
(RTE D 00:05:00 "(PWR 0)")
(RTE G 5 H "(DLY 100) (PWR 0)") = When pin 5 goes high, delay 100ms, then
(RTE?)
(RTE!000 T 2003/07/09 05:00:00 S "(PWR 0)")
(RTE!001 T 2003/07/09 12:36:45 S "(PWR 1)")
(RTE!002 T 2003/07/09 18:00:00 D "(PWR 0)")
(RTE?0)
(RTE!000 T 2003/07/09 05:00:00 S "(PWR 0)")
(RTE X 1): delete entry one
(RTE X *): delete all entries
(RTE X d): delete all pending events waiting because of a (DLY) command
B-41
P3 only applies if:
P2 = 1 (Power)
If P3 is 0 = Power Off
If P3 is 1 = Power On
P2 = 2 (Error)
P3 = error number
P2 = 5 (Signal Input)
P3 = Input number
P2 = 6 (Signal Channel)
P3 = Channel Number
Description
FUNC key event
1-5, 7-9
Description
System event
* = Delete all events
d = Delete all pending events
waiting because of a DLY
command.
Number = Delete the event
with the given number from
the list
= "S" Single / one time
= "D" Daily
// freeze image when FUNC-3 pressed
= In 5 minutes, turn the projector off
power off.
Appendix B ► Serial Communications
This optional parameter further
defines the state. If this is
omitted, assume the event will
fire on any system event of this
type (for example, all signal
input changes rather than a
specific one)
Meaning
This is a real-time event that
triggers a command when the
specified FUNC # is pressed.
The number to trigger from.
Meaning
This deletes a stored event.
This parameter determines
which events will be deleted.
Advertisement
Table of Contents
