Frame Delay; For Your Information - Wolf cinema DCX-500i Owner's Manual

Appendix B ► Serial Communications
3.53 fRD

frame Delay

3.54 fRz
freeze Image
3.55 fse
fan sensor enable
3.56 fYI

for Your Information

fRD fRaMe DelaY
Use FRD to adjust the number of lines of delay between the input and output frames (range
varies with incoming signal).
fRz fReeze IMage
FRZ 1 = freeze the image. FRZ 0 = unfreeze the image.
fse fan sensoR enable
Use FSE if you want the projector to shut down 3 minutes after a critical cooling fan failure. FSE
1 = enabled, FSE 0 = disabled. NOTE: Definition of a which cooling fan is critical varies with
projector model.
fYI foR YoUR InfoRMaTIon
The projector broadcasts an FYI message when it detects a change in status. The FYI message
contains the relevant status code followed by its new state (P1), up to 2 additional parameters of
detail, and a brief text description. The address of the source projector precedes the FYI code.
noTe: FYI messages are gated by the Error Message Enable (EME) control. Turning off EME
also turns off FYI.
status Code new state (P1)
001 Power 0 = Off 1 = On 2 = Boot 10
= Cool Down 11 = Warm Up
002 Proj. Address ##### (5-digit address)
003 Proj. Selected 0 = RS232 Inactive, UI
Inactive 1 = RS232 Inactive,
UI Active 2 = RS232 Active,
UI Inactive 3 = RS232
Active, UI Active
004 Baud Rate ####### (7-digit baud rate)
005 Standby 0 = Off 1 = On
006 Signal 0 = Good Signal 1 = Signal
missing 2 = bad sync
007 OSD 0 = Off 1 = On
009 Shutter 0 = Open 1 = Closed
010 Input 0 = Open 1 = Closed
011 Picture Mute. 0 = Off 1 = On
012 PIP. 0 = Off 1 = On
255 General / Misc. ### (3-digit channel
number)
B-22
Meaning and additional Parameters
P1 value indicates the new "Power" state
detected.
P1 value indicates the new address of
this source projector.
This projector has been activated or
inactivated via the PROJ key or the APJ
serial message.
P1 value indicates the new baud rate.
P1 value indicates whether the system is
in standby mode
P1 describes signal detection P2 = hor.
frequency of signal P3 = vert. frequency
of signal
P1 value indicates whether the on-
screen display is on or not.
P1 value indicates whether the shutter is
open or closed.
P1 describes the current channel
number P2 = Switcher# (projector is
always switcher "000") P3 = Slot#
P1 value indicates whether the picture is
displayed or not
P1 value indicates whether Picture-in-
Picture mode is on or not
P1 describes miscellaneous general
state detected