Wolf cinema DCX-500i Owner's Manual page 137

Professional 3-chip projectors
Hide thumbs Also See for DCX-500i:
Table of Contents

Advertisement

Reading the Configuration of a Port
P1 = <c>'port'
sending arbitrary Data out a Port
P1 = Port
P2 = Data
Reading arbitrary Data from a Port
P1 = Port
3.129 Rog
Rog ReD oDD gaIn
Red odd gain
Set or request the red Odd Gain (0-255) for a specific source setup. You can set an Odd Gain
value for two separate analog input paths. The first input path is Input 1 (BNC connectors). The
second input path is one of: Input 2 (DVI-A connector), or Input 5 or Input 6 (one of the analog
option cards).
To leave one of the input values unaffected, enter a value of 0 for the input. If only one value is
specified, then both input paths will have the same value.
3.130 Roo
Roo ReD oDD offseT
Set or request the blue Odd offset (0-255) for a specific source setup. You can set an Odd Offset
Red off offset
value for two separate analog input paths. The first input path is Input 1 (BNC connectors). The
second input path is one of: Input 2 (DVI-A connector), or Input 5 or Input 6 (one of the analog
option cards).
To leave one of the input values unaffected, enter a value of 0 for the input. If only one value is
specified, then both input paths will have the same value.
Same values for 'port' as above
example:
(REM? C2): Returns (REM! C002 r 0115200)
Same values for 'port' as above
The data to send out the specified port
examples:
(REM 2 "A123"): The data A123 is sent out the OUT port without any other protocol
characters. Some codes are not standard ASCII characters. These can be sent by
using any of the escape codes defined in the section on text parameters.
(REM 2 "123\h1645): Sends the following bytes: 0x31,0x32,0x33,0x16,0x34,0x35
Same values for 'port' as above
example:
(REM? 2): Returns (REM! 002 "1234"). "1234" is the data returned from the remote
equipment.
examples:
(ROG 130 135)
Sets the BNC analog path to 130, the DVI/option card path to 135.
(ROG 0 120)
Leaves the BNC path as it was, the DVI/option card path to 120.
(ROG 125)
Sets both paths to 125.
B-39
Appendix B ► Serial Communications

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dcx-1000iDcx-500fdDcx-1000fdDcx-1500fdDcx-1500i

Table of Contents