Advertisement
buttons on the remote control more than once within two seconds in order for the
fireplace to operate properly.
•
Press the standby button
flame effect.
Press the "750W" button once for low heat setting. Press the button again to switch off
•
the heat.
Press the "1500W" button once for high heat setting. Press the button again to switch off
•
the heat.
Press the "DIMMER" button to change the flame color. Every time you push the button,
•
the colors will change in the following order:
o
Amber
o
Red
o
Green
o
Blue
o
Red and Green
o
Red and Blue
o
Green and Blue
o
Red and Amber
o
Green and Amber
o
Blue and Amber
Auto Safety Shut-Off Mechanism
•
This fireplace is equipped with a safety shut-off feature which initiates if the fireplace
overheats (e.g. Due to blocked air vents). For safety reasons, the fireplace will NOT
automatically reset, and will need to be manually turned ON.
•
To restart the fireplace, unplug the fireplace from the power outlet for at least 15 minutes.
Next, reconnect to the power outlet and turn on the fireplace.
Troubleshooting
Unit does not work / does not heat
No flame effect
on the remote control once to turn on the fireplace with
Problem
Possible Solution
!
Check if the unit is plugged in the power
outlet.
!
Check if the unit is in Standby mode. If so,
turn the unit ON.
!
Check if the heat is turned OFF.
!
Check for safety cut-off operation.
!
Check if the unit is plugged in the power
outlet.
!
Check if the unit is in Standby mode. Turn
the unit ON.
8
Advertisement
