Troubleshooting - Frigidaire Madrid Vwwf-1/0307 Important Instructions & Operating Manual

Replacing the Light Bulb
This fireplace consists of 4 bulbs (E-12, 40W) that illuminate a flame effect. The light
•
bulbs need to be replaced if you notice a dark section of the flame or when the flames
lose clarity.
Warning - Always disconnect from the power outlet before removing bulbs to reduce the
•
risk of fire, electric shock or damage to property.
Warning - The bulb reaches high temperatures during operation. Allow it to cool down
•
before replacing it.
• This process requires 2 people.
Un-mount the fireplace and carefully lay it flat on the floor.
•
• Access the bulb by removing the four screws located on the back panel.
Replace the bulb with a new one. Extra caution should be taken because the bulb can
•
be hot.
Close the panel lid using screws.
•
Warning – Do not use fireplace without properly putting the lid back in place.
•
• For assembly, reverse this process.

Troubleshooting

Unit does not work / does not heat
No flame effect
Problem Possible Solution
!
Check if the unit is plugged in the power
outlet.
!
Check if the unit is in Standby mode. If so,
turn the unit ON.
!
Check if the heat is turned OFF.
!
Check for safety cut-off operation.
!
Check if the unit is plugged in the power
outlet.
!
Check if the unit is in Standby mode. Turn
the unit ON.
9