Wall mount vertical style led fireplace (10 pages)
Summary of Contents for Frigidaire Vienna VWF-1 0305
IMPORTANT INSTRUCTIONS & OPERATING MANUAL Vienna 2 in 1 (Wall Mount & Floor Standing) Color Changing LED Fireplace Item No: VWF-1/0305 Read these instructions carefully before attempting to assemble, install, operate or maintain the product. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and / or property damage.
GENERAL SAFETY INFORMATION When using this fireplace, basic precautions should always be taken to reduce the risk of fire, electric shock and injury to persons, including the following: CAUTION – Due to the high temperature, keep electrical cords, drapery and other furnishings at least 3 feet from the front, side and rear of the fireplace.
23. Faulty wall outlet connections may cause the wall outlet to overheat. Be sure that the fireplace plug properly fits into the outlet before each use. During use, make sure the fireplace plug does not overheat. If necessary, have a qualified electrician check and / or replace the wall outlet. 24.
Quick Reference Guide Prior to installation, please ensure that the voltage and capacity of your power outlet is compatible with your fireplace. Your fireplace may emit a slight, harmless odor during its first use. This odor is a normal reaction caused by the initial heating of internal fireplace parts and it will not occur again.
Helpful Advice Before Installation Please retain all packaging until you have checked and counted all the parts and other package contents. The package contains small apparatus which should be kept away from young children and infants. We suggest that you move all the smaller parts into a container to reduce the risk of losing them. ...
34.6 inch 6.3 inch 2 feet Step One Keep the top of the fireplace at least 3 feet away from the ceiling or other objects for optimum heat ventilation. For optimum viewing, place four marks on the wall with respect to the recommended fixed dimensions for the top screws (see figure below).
Step Two Make sure the area to be drilled does not have any hidden electrical wires or water and gas pipes. The wall fixings provided is for concrete walls only; please use suitable fixings for your wall type. If in doubt, contact a qualified hardware expert.
Step Five Place the front glass panel over the front of the fireplace aligning the slots in the brackets at each side of the front panel with the knobs on the sides of the fireplace. Slot the front facade down ensuring that the brackets are fully interlocked.
Installation (Floor Standing) Place the fireplace on a flat table. Attach the floor standing base to the fireplace using the provided screws. Place the fireplace upright. Unpack the pebbles from the bag and place them along the unit in the desired position. Please note the pebbles are located inside the polystyrene bag.
Place the front glass panel over the front of the fireplace aligning the slots in the brackets at each side of the front panel with the knobs on the sides of the fireplace. Slot the front facade down ensuring that the brackets are fully interlocked. ↓...
Remote Control Operation (continued) Press the standby button on the remote control once to turn on the fireplace with flame effect. Press the “750W” button once for low heat setting. Press the button again to switch off the heat. ...
Cleaning & Maintenance Disconnect from the power supply before attempting any maintenance or cleaning in order to reduce the risk of fire, electric shock to persons or damage to property. Warning - Always disconnect from the power supply before cleaning fireplace. ...