Whirlpool Cabrio WTW6400S Technical Manual page 71

Manual: Door Switch
Opening the door should cause the Clothes
Clean or Done status indicator to turn off.
Closing the door should cause the indicator
to turn on.
• If Clothes Clean or Done indicator does not
turn off or on, go to TEST #8.
Manual: Door Lid Lock
NOTE: Door must be closed. If door is not
closed, an invalid button press beep will oc-
cur when performing next step.
Press and release:
2nd RINSE
Door locks, lid lock indicator turns on.
or EXTRA RINSE
Repeat Door unlocks, lid lock indicator turns off.
• If door does not lock or unlock, go to TEST
#8.
Manual: Motor
Rotor Position Sensor (RPS): Uses Wash,
Rinse and Spin indicators to detect the three
rotor position sensors. Console may have up
to two of these indicators on at one time when
the basket is not moving. Open door and ro-
tate basket by hand. The Wash, Rinse and
Spin status indicators should toggle on and
off according to direction the basket is being
turned.
• If none of these indicators are on go to
TEST #3.
Spin: To activate Spin, door must be closed
with door lock enabled. See Manual: Door Lid
Lock.
NOTE: If door is not closed, an invalid button
press beep will occur when performing next
step.
Press and release:
SPIN SPEED, WATER
LEVEL or LOAD SIZE
Repeat
Repeat
Repeat
NOTE: Indicators above button scroll from
top to bottom.
• If motor fails to spin, go to TEST #3.
Motor/basket spins at 23 rpm.
Motor/basket spins at 530 rpm.
Motor/basket spins at 1000 rpm.
Motor turns off.
Agitate: Water must cover the wash plate (or
agitator vanes) to ensure the basket is float-
ing prior to agitation. Enabling agitation with-
out enough water may cause a fault condition
to occur. See Manual: Water Valves.
Press and release:
SOIL LEVEL
Repeat
Repeat
Repeat
NOTE: Indicators above button scroll from
top to bottom.
• If motor fails to agitate, go to TEST #3.
ACTIVATION OF CONSOLE AND
INDICATORS DIAGNOSTIC TEST MODE
This test checks the cycle selector knob, indi-
cators, buttons, two-digit display and beeper.
1. Plug in washer or reconnect power.
2. Read through step 3 before continuing.
From Standby (Off) Mode press and re-
lease (key-dance) the following buttons
within 4 seconds:
SOIL WASH/RINSE
LEVEL TEMP
If successful, two-digit dt will display and
you will have 5 seconds to complete next
step.
3. Within 5 seconds of dt showing in display,
press START (all indicators in display are
illuminated and 88 is displayed).
• Press START a second time. This
turns off status indicators and two-digit
display (all other indicators remain il-
luminated).
• Press START a third time. This turns
on status indicators and two-digit dis-
play (all indicators are illuminated).
4. Rotate WASH CYCLE selector back and
forth. Indicators will toggle on (or off).
6-7
Gentle wash action.
Normal wash action.
Heavy wash action.
Motor turns off.
SOIL WASH/RINSE
LEVEL TEMP