Whirlpool Cabrio WTW6400S Technical Manual page 70

2. If done successfully, a single beep oc-
curs and the two-digit display shows one
of the following console ID#s: 06, 08, 12,
13, 14, 15, 16, 17, 18, 19, 20, 21, 44, 45,
46, 47, 48, 49, 60, 61, 62 for 3 seconds,
then displays 00 and the Add A Garment
indicator LED flashes. See Diagnostic:
Manual.
• If entry into Manual Diagnostic mode
is successful, but none of the console
ID#s above are displayed, replace the
user interface assembly. See Access-
ing & Removing the Electronic Assem-
blies.
DIAGNOSTIC: Manual
Assumes Manual Diagnostic mode has been
entered, two-digit display shows 00, and ADD
A GARMENT indicator is flashing.
NOTE: If there is no activity (button press,
cycle select) within 5 minutes, the control au-
tomatically exits Diagnostic mode and enters
standby mode.
Manual: Water Valves
To check FRESH valve select or press the
following:
WHITES/WHITES • START (turns on
Fresh valve, cycle indicator flashes) •
WASH/RINSE TEMP (enables fill of Hot,
Warm, Cold or no water according to
WASH/RINSE TEMP selection and in-
dicator) • START (turns off Fresh valve,
cycle indicator is steady on).
To check DETERGENT valve select or press
the following:
HEAVY DUTY • START (turns on De-
tergent valve, cycle indicator flashes) •
WASH/RINSE TEMP (enables fill of Hot,
Warm, Cold or no water according to
WASH/RINSE TEMP selection and indi-
cator) • START (turns off Detergent valve,
cycle indicator is steady on).
To check FABRIC SOFTENER valve select
or press the following:
NORMAL • START (turns on Fabric
Softener valve, cycle indicator flashes) •
WASH/RINSE TEMP (enables fill of Hot,
Warm, Cold or no water according to
WASH/RINSE TEMP selection and indi-
cator) • START (turns off Fabric Softener
valve, cycle indicator is steady on).
To check BLEACH valve select or press the
following:
CASUAL • START (turns on Bleach valve,
cycle indicator flashes) • WASH/RINSE
TEMP (enables fill of Hot, Warm, Cold
or no water according to WASH/RINSE
TEMP selection and indicator) • START
(turns off Bleach valve, cycle indicator is
steady on).
NOTE: Washer can only fill cold through
Bleach valve.
• If any valve fails to turn on go to TEST #2.
Manual: Pumps
Models with Push-button cycles:
Press and release:
CLEAN WASHER
or DRAIN & SPIN
Repeat
Repeat
Repeat
Models using Cycle Selector:
Select CLEAN WASHER or DRAIN & SPIN.
Press and release:
START
Repeat
Repeat
Repeat
• If pumps fail to turn on go to TEST #7.
6-6
Turns on recirculation pump, indicator is
steady on.
Turns off recirculation pump, indicator
turns off.
Turns on drain pump, indicator flashes.
Turns off drain pump, indicator turns off.
Turns on recirculation pump, cycle
indicator is steady on.
Turns off recirculation pump, indicator
turns off.
Turns on drain pump, indicator flashes.
Turns off drain pump, indicator turns off.