Status Lights - Whirlpool Cabrio WTW6400S Technical Manual

CHANGING MODIFIERS AND OPTIONS
AFTER PRESSING START
You can change a Modifier or Option anytime
before the selected Modifier or Option begins.
You must:
1. Press PAUSE/CANCEL once.
2. Select the desired Modifiers and/or Op-
tions.
3. Press START.
TO MANUALLY DRAIN THE WASHER AND
SPIN THE LOAD
1. Press PAUSE/CANCEL twice to cancel
the wash cycle and drain the washer.
2. Press POWER.
3. Turn knob to select DRAIN & SPIN.
4. Press START.
When the spin is complete, the lid unlocks.
Items can be removed from the washer.

STATUS LIGHTS

These lights show which portion of the cycle the
washer is operating. They also indicate when
you can add other garments to the wash load.
LOAD IS DONE
The Done light stays on until the lid is opened
or the Power button is pressed.
INDICATOR LIGHTS
An indicator light shows which Cycle, Modifiers
and Options you have selected.
ESTIMATED TIME REMAINING
When a wash cycle is started, the estimated
time remaining for the cycle, including fills and
drains, will be displayed. The time will count
down to the end of the cycle.
CYCLES
Turn the knob to choose the right wash cycle
for the type of fabrics you are washing. When
the knob points to a cycle, the indicator light
for the cycle will glow and the indicator light
for Start will blink. If the default settings for the
Modifiers and Options are acceptable, you may
press Start to begin the wash cycle.
PRESET CYCLE SETTINGS
For ease of use, preset cycle settings provide
the recommended fabric care settings for each
cycle.
To use the preset cycle settings:
1. Press POWER.
2. Select the cycle you want by turning the
knob. The preset cycle settings will be dis-
played (see the chart on the next page).
NOTE: The preset times may vary slightly
depending on your model.
3. Press START. The wash cycle will begin.
3-6