Manitowoc S Installation, Use & Care Manual page 27

Section 4
Multiple Evaporator Ice Machines
A. Remove front evaporator shield
• Remove four quarter turn connectors.
• Remove splash shield.
B. Remove left and right evaporator top covers
• Remove two thumbscrews from the front of each
evaporator top cover.
• Lift front of cover, pull forward to remove.
C. Remove splash shields
NOTE: Each evaporator has a splash shield that must
be removed - total of four splash shields.
• Grasp the top center of splash shields.
• Lift up and then out.
D. Remove ice thickness probe
• Compress the hinge pin on the top of the ice
thickness probe.
• Pivot the ice thickness probe to disengage one pin
then the other. The ice thickness probe can be
cleaned at this point without complete removal. If
complete removal is desired, disconnect the ice
thickness control wiring from the control board.
E. Remove the water pump assembly
• Disconnect the vinyl distribution tube from both water
pumps.
• Disconnect the water pump and water level probe
electrical connections.
• After the wires are disconnected remove the two
thumbscrews and lift the water pump assembly out of
the ice machine.
A
C
Part Number 000006520 11/11
B E
D
F
• Remove the thumbscrews securing the water pumps
(2 each pump) and remove water pumps. Do not
immerse the water pump motor in cleaner or sanitizer
solutions.
• Remove the water level probe from the assembly
housing.
F. Remove the water trough
• Pull forward on the water trough to remove.
G. Remove distribution tubes
NOTE: Each evaporator has a distribution that must be
removed - total of four distribution tubes.
• Distribution tube thumbscrews are retained to
prevent loss. Loosen thumbscrews but do not pull
thumbscrews out of distribution tube.
• Loosen the two outer screws and pull forward on the
distribution tube to release from slip joint.
• Disassemble distribution tube by loosening the two
(2) middle thumbscrews and dividing the distribution
tube into two pieces.
H. Remove ice dampers
NOTE: Each evaporator has an ice damper that must be
removed - total of four ice dampers.
• Grasp ice damper and apply pressure toward the
back mounting bracket.
• Apply pressure to the front mounting bracket with
thumb.
• Pull ice damper downward when the front ice damper
pin disengages.
G
H
Maintenance
27