General - Manitowoc S Installation, Use & Care Manual

S model
Hide thumbs Also See for S:
Table of Contents

Advertisement

Available languages

Available languages

Installation Instructions

GENERAL

Condensers must be mounted horizontally with the fan
motor on top with nothing obstructing it. There must be
at least a 16" (41 cm) clearance from the bottom for air
intake. The front coupling panel and one other panel
(back or side) must also be unobstructed.
Remote condenser installations consist of vertical and
horizontal line sets between the ice machine and the
condenser. When combined, they must fit within
approved specifications. The following guidelines,
drawings and calculation methods must be followed to
verify a proper remote condenser installation.
! Caution
The 60 month compressor warranty (including the
36 month labor replacement warranty) will not apply
if the remote ice machine is not installed according
to specifications.
This warranty also will not apply if the refrigeration
system is modified with a condenser, heat reclaim
device,
or
other
manufactured by Manitowoc Ice unless specifically
approved in writing by Manitowoc Ice.
3
2
1
Routing Line Sets
12
parts
or
assemblies
DOWNWARD
HORIZONTAL
SPIRAL
2
1
GUIDELINES FOR ROUTING LINE SETS
First, cut a 2.5" (6.35 cm) circular hole in the wall or roof
for tubing routing. The line set end with the 90° bend will
connect to the ice machine. The straight end will connect
to the remote condenser.
Follow these guidelines when routing the refrigerant
lines. This will help ensure proper performance and
service accessibility.
1. Optional - Make the service loop in the line sets (as
shown below). This permits easy access to the ice
machine for cleaning and service. Do not use hard
rigid copper at this location.
2. Required - Do not form traps in the refrigeration lines
(except the service loop). Refrigerant oil must be
free to drain toward the ice machine or the
condenser. Route excess tubing in a supported
downward horizontal spiral (as shown below). Do
not coil tubing vertically.
3. Required - Keep outdoor refrigerant line runs as
short as possible.
not
3
Section 2
Part Number 000006520 11/11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents