Right-Side Components; Removing Right-Side Components - Arctic Cat Prowler Service Manual

29. In a crisscross pattern starting from the center and
working outward, tighten the cap screws securely.
30. Adjust valve/tappet clearance (see Section 2).
31. Place the two tappet covers into position making
sure the proper cap screws are with the proper
cover. Tighten the cap screws securely.
32. If removed, install the spark plug. Tighten to 12
ft-lb.

Right-Side Components

NOTE: For efficiency, it is preferable to remove
and disassemble only those components which
need to be addressed and to service only those
components. The technician should use discretion
and sound judgment.
AT THIS POINT
To service any one specific component, only limited
disassembly of components may be necessary. Note
the AT THIS POINT information in each sub-section.
NOTE: The engine/transmission does not have to
be removed from the frame for this procedure.
Back
3-24
CC003D
CC001D
Back to TOC
Removing Right-Side
Components
A. Water Pump
B. Right-Side Cover
C. Rotor/Flywheel
1. Remove the four screws securing the outer mag-
neto cover to the right-side cover; then remove the
cover. Account for the gasket.
2. Remove the flange nut securing the spacer to the
crankshaft; then remove the spacer. Account for
the O-ring.
3. Using a cold chisel, scribe a mark showing the rel-
ative position of the shift arm to the shift arm shaft
to aid in installing; then remove the shift arm.
4. Remove the two cap screws securing the speed
sensor housing; then remove the housing. Account
for the gasket and two seal washers.
Back to Section TOC
PR465
PR429A
Next