Center Crankcase Components; Separating Crankcase Halves; Disassembling Crankcase Half - Arctic Cat Prowler Service Manual

Center Crankcase
Components
NOTE: This procedure cannot be done with the
engine/transmission
Removing procedures for Top-Side, Left-Side, and
Right-Side must precede this procedure.
NOTE: For efficiency, it is preferable to remove
and disassemble only those components which
need to be addressed and to service only those
components. The technician should use discretion
and sound judgment.
Separating Crankcase
1. Remove the left-side cap screws securing the
crankcase halves. Note the location of the differ-
ent-lengthed cap screws.
2. Remove the right-side cap screws securing the
crankcase halves. Note the location of the differ-
ent-lengthed cap screws.
3. Using the
Remover and tapping lightly with a rubber mallet,
separate the crankcase halves. Account for four
alignment pins.
NOTE: To keep the shaft/gear assemblies intact
for identification, tap the shafts toward the
right-side crankcase half when separating the
halves.
Back
in the frame. Complete
Halves
Crankcase Separator/Crankshaft
Back to TOC
CD083
Disassembling
Crankcase Half
NOTE: For steps 1-7, refer to illustration CC821B.
KEY
A. Secondary Driven Shaft
Assembly
B. Crank Balancer Gear
C. Crankshaft Gear
D. Countershaft Assembly
NOTE: To aid in installing, it is recommended that
the assemblies are kept together and IN ORDER.
1. Remove the secondary driven shaft assembly (A)
noting the location of the bearing locating pins.
Account for the bearing C-ring.
Back to Section TOC
CC665
E. Driveshaft
F. Reverse Idler Gear Assembly
G. Gear Shift Shaft
H. Shift Shaft with 2 Forks
CC821B
CD267
Next
3-37
3