Periodic Maintenance; Lubrication Points; Battery - Arctic Cat Prowler Service Manual

Periodic Maintenance

This section has been organized into sub-sections
which show common maintenance procedures for the
Arctic Cat UTV.
NOTE: Arctic Cat recommends the use of new
gaskets, lock nuts, and seals and lubricating all
internal components
engine/transmission.
NOTE: Some photographs and illustrations used
in this section are used for clarity purposes only
and are not designed to depict actual conditions.
NOTE: Critical torque specifications are located
in Section 1.
SPECIAL TOOLS
A number of special tools must be available to the
technician when performing service procedures in this
section.
Description
Compression Tester Kit
Oil Filter Wrench
Timing Light
Valve Clearance Adjuster
NOTE: Special tools are available from the Arctic
Cat Service Parts Department.

Lubrication Points

It is advisable to lubricate certain components periodi-
cally to ensure free movement. Apply light oil to the
components using the following list as reference.
A. Accelerator Pedal Pivot/Cable Ends
B. Brake Pedal Pivot
C. Parking Brake Cable Ends
D. Shift Linkage
E. Differential Lock Cable End
F. Idle RPM Screw
Back
when servicing the
p/n
0444-213
0644-389
0644-296
0444-078
Back to TOC

Battery

The battery is located in a compartment in front of the
left-rear wheel under the driver seat.
NOTE: To access the battery box, the left-rear
fender splash panel must be removed.
After being in service, batteries require regular clean-
ing and recharging in order to deliver peak perfor-
mance and maximum service life. The following
procedures are recommended for cleaning and main-
taining lead-acid batteries. Always read and follow
instructions provided with battery chargers and battery
products.
! WARNING
Anytime service is performed on a battery, the fol-
lowing must be observed: keep sparks, open flame,
cigarettes, or any other flame away. Always wear
safety glasses. Protect skin and clothing when
handing a battery. When servicing battery in
enclosed space, keep the area well-ventilated. Make
sure battery venting is not obstructed.
1. Remove the battery hold-down; then disconnect
the battery cables (negative cable first).
2. Disconnect the vent hose.
3. Remove the battery from the vehicle; then thor-
oughly wash the battery and battery compartment
with soap and water.
NOTE: If battery posts, cable ends, or the battery
case has a build-up of white/green powder residue,
apply water and baking soda to neutralize acid;
then flush off with warm soapy water.
4. Using a wire brush, clean the battery posts and
cable ends removing all corrosive buildup.
Replace damaged cables or cable ends.
5. Add clean distilled water to bring fluid level to the
UPPER level line.
! WARNING
Battery acid is harmful if it contacts eyes, skin, or
clothing. Care must be taken whenever handling a
battery.
! CAUTION
Never use electrolyte (sulfuric acid) to "top off" the
battery. Use only distilled water or severe battery
damage may occur.
6. Using a multimeter, test the battery voltage. The
meter must read at least 12.5 DC Volts for a fully
charged battery.
Back to Section TOC
2
Next
2-3