Installing Engine/Transmission - Arctic Cat Prowler Service Manual

10. In a crisscross/case-to-case pattern, tighten the 6
mm cap screws (from steps 7-8) to 8 ft-lb.
NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs.
AT THIS POINT
After completing center crankcase components,
proceed to Installing Left-Side Components, to
Installing Right-Side Components, and to Installing
Top-Side Components.
Installing
Engine/Transmission
NOTE: Arctic Cat recommends that new gaskets
and O-rings be installed whenever servicing the
vehicle.
1. Attach suitable lifting chains to the engine/trans-
mission; then using an engine hoist, lower the
assembly into the engine compartment.
! WARNING
Keep hands and fingers clear when lowering the
engine/transmission into place. The chains could
shift causing severe injury.
! CAUTION
Make sure that all wiring, hoses, and brake lines are
routed away from engine mounts and engine brack-
ets. Pinching or breaking of lines or shorting of wir-
ing could occur.
NOTE: The rear engine mounting bracket and
rear engine mounts should be attached to the
engine. The front engine mounting bracket should
be attached to the engine, and the front engine
mounts should be in the frame.
Back
PR114
Back to TOC
2. Align the rear engine mount studs with the holes in
the frame and slowly lower into place. The front
engine mounting bracket will then slip over the
engine mount studs.
3. Install the flange nuts on the rear engine mount
studs; then secure the front engine mounting
bracket to the front engine mount studs with two
flange nuts. Tighten the four flange nuts to 25
ft-lb.
4. Apply multi-purpose grease to the driveshaft
splines; then align the flange marks and slide the
splines into the slip-joints.
Back to Section TOC
PR146
3
PR153A
PR147
Next
3-45